OEM UVCD 2
N.I.R. Vacuum drier 500/800 pairs in 8 hours




UVCD 2 carries out for both shoes and boots with the relevant soles, the following functions:

- ULTRARAPID CEMENT DRYING (water base or solvent)
- ULTRARAPID CEMENT ACTIVATION

The system consists of a pre-chamber where the cement is warmed up and of a vacuum treatment chamber where, together with the use of the special N.I.R. lamps, with high penetration and low power consumption infra-red rays, the total cement drying and the relevant reactivation are obtained. The use of N.I.R. lamps in a vacuum environment allows to treat the shoes and the soles (at different treatment temperatures) in a very short time and therefore with a high output in a reduced room. The highly innovative solutions used for the realization of UVCD 2, also allow, to get a high energy saving as follows:

• In a vacuum environment the water and the solvent evaporate at temperatures very much lower than 100° C.
• The N.I.R. lamps reach the set temperature almost immediately.
• Some special reflectors recover all the infra-red rays which are then directly projected on the shoe and on the sole.
• An electronic system trips the N.I.R. lamps by impulse, with rapid on and off.
• The N.I.R. lamps absorptions are adjusted in percentage form 0 up to 100% by proper electronic devices, according to the drying and reactivation results obtained at the end of the process.
• During the forward movement of the conveyor, the N.I.R. lamps automatically switch off.
• The non accumulation of heat inside the last, thanks to the very short treatment time, allows the use of a less powerful chiller.